The Omron E2EQ-X22B1D30-M1TJ 0.3M is a shielded M30 inductive proximity sensor with a 22 mm sensing distance, PNP normally open output, and a 0.3 m M12 pigtail with Smartclick connector. The fluororesin coating resists welding slag, making it a go-to choice for automotive body shops and fabrication cells where spatter would destroy an uncoated sensor. IO-Link COM2 communication is available on the same 3-wire DC supply (10-30 VDC), enabling parameter adjustment and diagnostics through an IO-Link master. The extended sensing range—triple the standard for a shielded M30—lets you mount it further back from the target, reducing collision risk. IP67 and IP67G protection means it handles both temporary immersion and gas penetration common in wet or compressed-air-rich environments.
Mounting and wiring notes
Short-body construction (overall length 60.3 mm, threaded length 38 mm) fits standard M30 clearance holes in brackets. Shielded design allows flush mounting without derating the sensing range. Brass case with fluororesin sensing face resists corrosion and abrasion. The M12 Smartclick connector latches by hand—no tool required—but verify the locking ring is fully engaged before tightening to avoid intermittent contact. Wire as a standard 3-wire PNP sensor: brown (V+), blue (V-), black (output). Ground through the housing if needed, but the sensor does not require it for operation.