The BEH18LH1533MF6C is a 1.5 kW servo motor from the Lexium 18 range, spinning at 3000 rpm nominal speed on single-phase 220 V supply. The 4.77 N.m nominal torque and 14.31 N.m peak stall torque define the acceleration headroom for a direct-drive or belt-coupled axis — the peak figure is what gets the load moving against inertia, not the continuous rating. The 17-bit magnetic multi-turn encoder gives 131,072 counts per revolution absolute position feedback, so the drive knows the rotor angle at power-up without a homing move. That matters on a vertical axis or a tool-changer where the machine must resume position after a power cycle without crashing. The holding brake is rated 8 N.m static torque — enough to hold a vertical load that the motor's 4.77 N.m continuous torque would otherwise back-drive when power is off. The brake releases electrically when the drive enables, so the axis is free to move under power.
IP67, Asian flange, air-cooled — integration into a washdown or food-grade line
IP67 protection means the motor body and the connector interface are sealed against dust ingress and temporary immersion — the motor can be hosed down on a food-processing or packaging line without water getting into the windings or encoder. The air-cooled surface design relies on free convection; no external fan or coolant lines to route. The Asian standard flange (100 mm square, 9 mm mounting holes) matches the common frame size used across the Lexium 18 family. The 24 mm shaft with parallel key and 45 mm shaft length takes a standard timing-belt pulley or coupling — no custom machining needed for most motion modules.