2 kW servo with 17-bit absolute feedback — the torque density fit
The BEH18LH2033MA6C delivers 2000 W continuous power with 6.37 N.m nominal torque at 3000 rpm, single-phase 220 V input. That torque constant of 0.53 N.m/A at 40 °C means the drive needs to supply 12 A continuous stall current to hold position under full torque — size the drive's continuous current rating above this, not just the peak. Peak stall torque hits 19.11 N.m at 36 A — a 3× overload for acceleration transients. The drive's peak current capability must match this for the duty cycle; a drive rated for 150% overload for 3 seconds typically covers it, but confirm the drive's peak current ceiling against the 36 A maximum Irms.
IP67 sealed body — washdown-ready without a secondary cover
IP67 rating on both the housing and the connector interface means this motor survives hose-down cleaning in food or beverage lines without an add-on shroud. The 2-connector male/female electrical connection is sealed at the mating face — verify the cable gland torque spec on the mating cordset to maintain the IP67 boundary. Air-cooled with a 100 mm Asian-standard flange. The 167.4 mm depth and 144.5 mm height fit the B14 footprint common on Asian-sourced machinery — measure the existing bolt pattern against the 9 mm mounting holes on a 100 mm PCD before ordering.
17-bit multi-turn absolute encoder — no homing on power-up
The 17-bit magnetic multi-turn encoder tracks absolute position over 131,072 counts per revolution and multiple shaft turns without battery backup. On a power cycle the drive knows the exact rotor position — no homing routine needed for axis re-initialisation. This eliminates the re-reference step after a line stoppage or emergency stop. The 10-pole motor design with a 24 mm parallel key shaft and 45 mm shaft length couples directly to most standard servo couplings. Maximum radial force is 686 N at the shaft centre — stay under this for belt-drive or overhung load applications to avoid bearing overload.