1000 W at 220 V single-phase — continuous torque rating
The BEH18MF1033CF5C delivers 1000 W continuous output power from a single-phase 220 V supply, with a nominal torque of 3.18 N.m and a continuous stall torque of the same 3.18 N.m. This means the motor can hold full rated torque at standstill indefinitely without overheating — a useful characteristic for indexing or clamping applications where the motor must hold position under load between moves. The peak stall torque reaches 11.13 N.m, providing a 3.5x overload margin for acceleration or transient loads, provided the drive can supply the corresponding peak current of 21 A.
Integrated holding brake and 23-bit multi-turn encoder
The motor includes a holding brake rated at 3.2 N.m, which engages when power is removed — this holds the load on a vertical axis or during an E-stop without relying on the drive to maintain DC bus voltage. The 23-bit optic multi-turn encoder provides absolute position feedback across 8,388,608 counts per revolution and tracks multiple shaft rotations, so the machine does not require a homing sequence after a power cycle. The encoder resolution supports high-precision positioning down to sub-arcminute levels, limited by the mechanical stiffness of the coupling and load.
IP67 sealed construction and Asian standard flange
The motor carries an IP67 rating, meaning the housing and connector interface are protected against dust ingress and temporary immersion in water — suitable for washdown environments in food processing or packaging lines. The mounting flange conforms to the Asian standard 80 mm flange pattern (four mounting holes), with a shaft diameter of 19.0 mm and a parallel key of 6.0 mm width. The overall dimensions — 142.1 mm wide, 80 mm high, 89.9 mm deep — define the clearance envelope in the machine frame. Maximum axial force is 147 N and maximum radial force is 392 N, which sets the allowable belt tension or direct-coupling load on the shaft bearings.