The BEH18MM1023CF6C is a 1 kW servo motor from the Lexium 18 family, rated 2000 rpm nominal speed at 220 V single-phase input. That 2000 rpm base speed suits applications like conveyors, indexing tables, and packaging machinery where moderate speed with precise position holding is required. Nominal torque is 4.77 N·m at 220 V, with a continuous stall torque matching that figure — so the motor can hold full rated torque at zero speed without overheating, as long as the cooling airflow is maintained. Peak stall torque reaches 14.31 N·m, giving a 3× overload margin for acceleration transients.
Integrated holding brake and feedback — fit for vertical-axis safety
A holding brake is built in, rated 16.0 N·m holding torque. This locks the rotor when power is removed — critical for vertical-axis loads (e.g., pick-and-place Z axes, elevating conveyors) that must not drift on power loss. Feedback comes from a 23-bit optic multi-turn encoder. The multi-turn absolute tracking means the controller knows the shaft position even after a power cycle, eliminating the need for a homing sequence on restart. The optic encoder resolution (23-bit = 8,388,608 counts per revolution) gives fine position granularity for precise velocity and position loops.
IP67 enclosure and Asian-standard flange — washdown-ready mounting
Rated IP67, the motor body and shaft seal withstands water ingress and dust — suitable for washdown environments in food processing, beverage lines, or outdoor material handling. The connector interface uses two male/female connectors, maintaining the seal when mated. Mounting uses an Asian-standard flange with a 130 mm flange size and four mounting holes. The shaft is 22 mm diameter with a parallel key (8 mm key width, 58 mm shaft length), matching common Asian-spec gearboxes and pulleys.
The BEH18MM1023CF6C is listed as current production (active lifecycle stage).