Motor ratings and load matching
The BEH18MM2023MF6C: Rated 2.0 kW continuous output at 220 V single-phase input, with a nominal speed of 2000 rpm and a nominal torque of 9.55 N·m. The maximum mechanical speed is 3000 rpm, giving headroom for overspeed applications. Peak stall torque reaches 28.65 N·m at the same 220 V single-phase supply — this is the short-duration overload capability for acceleration or emergency stop, not the continuous rating. The integrated holding brake delivers 16.0 N·m of static torque, enough to hold a vertical-axis load at rest without the drive holding current. The brake engages when power is removed, so a vertical load won't drop on a power loss.
Feedback and environmental sealing
17-bit magnetic multi-turn encoder provides absolute position feedback over 131,072 counts per revolution — no homing cycle needed after a power cycle. The magnetic sensing is immune to dust and oil film that would blind an optical encoder. IP67 rating means the motor body and shaft seal are protected against temporary immersion and high-pressure washdown. This makes it suitable for food processing, packaging lines, and other wet environments where coolant spray or washdown is routine.
Physical fit and mounting
Air-cooled with no external fan requirement — the motor relies on natural convection and the shaft-mounted fan. Confirm adequate clearance around the housing for airflow, especially in a confined cabinet.
Electrical characteristics and drive pairing
Motor has 10 poles and a torque constant of 0.92 N·m/A at 40 °C. Continuous stall current is 10.38 A; maximum permanent current is 31.14 A at 2.0 kW. The back EMF constant is 63.35 V/krpm, so at 2000 rpm the motor generates about 126.7 V line-to-line back EMF — important for sizing the DC bus voltage margin in the drive. Electrical connection uses two male/female connectors — one for power, one for feedback. No cable gland dimensions are given; verify the connector type (likely M23 or M17) against the drive cable set before ordering.