The Bosch Rexroth BMI0703P06A is a three-phase servo motor delivering 900 W nominal output on a 400 V supply, with absolute single-turn SinCos Hiperface feedback. Rated torque depends on supply voltage: 2.9 Nm at 208 V, 2.7 Nm at 400 V, and 2.3 Nm at 480 V. Peak stall torque hits 8.6 Nm across the entire voltage range, so the motor can handle short overloads without derating. Feedback is absolute single-turn SinCos Hiperface — no homing sequence required on power-up; position is known immediately after the drive reads the encoder.
Mechanical interface: 70 mm flange (international standard), 14 mm shaft diameter, 30 mm shaft length. The shaft end is untapped — no threaded hole for a face-mounted coupling, so plan for a clamp-style hub. Length is 300 mm (11.8 in) overall. The motor has an integrated EMC filter, which cuts panel space and avoids an external filter for drive-side compliance. Protection: housing IP65, shaft IP54. Cooling is natural convection — no fan needed, but keep adequate clearance around the housing for heat dissipation. Electrical connection via printed circuit board connector; specify the mating drive connector to match pinout.