Motor with the bolt-on extras already inside
The BMI0703P26F is a three-phase servo motor from Schneider's BMI series, sized for a 70 mm international standard flange and delivering 900 W nominal output at 400 V and 480 V three-phase, 450 W at 208 V three-phase. Nominal torque runs 2.7 Nm at 400 V, 2.9 Nm at 208 V, 2.3 Nm at 480 V; peak stall torque holds 8.6 Nm across all three voltages. The motor ships with an integrated holding brake (3 Nm holding torque, 5 W pull-in power) and an absolute single-turn SinCos Hiperface feedback, so you don't need an external brake chopper or a separate encoder interface. The integrated EMC filter and natural convection cooling keep panel wiring and ventilation simple — no external filter needed for most installations, and no cooling fan to fail. IP65 rating means the motor can handle washdown and dust without an extra cover.
Sourcing and lifecycle — current and spec'd, no scavenger hunt
Verify flange size (70 mm), shaft diameter (14 mm), feedback type (Hiperface absolute single-turn), and voltage range (208–480 V three-phase) against your existing bracket and drive.
Fitting and wiring notes
Motor length is 339 mm from mounting face to rear. Shaft is 14 mm diameter, 30 mm long, untapped — no through-bolt hole. Centring collar depth is 2.5 mm. Electrical connection uses PCB connectors. Motor mounts via four holes on 70 mm flange. Rated for supply voltage 208–480 V three-phase, 50/60 Hz ±5 %. Maximum current Irms is 12.5 A at any of the three voltage levels. Continuous stall torque is 3.4 Nm across the full voltage range. The motor has 10 poles, three stacks. For radial load capacity, see the speed-dependent Fr values — 730 N at 1000 rpm down to 400 N at 6000 rpm. Axial force limit is 20 % of the radial load at the given speed.