What you’re ordering – fit and ratings that matter
The BMI1002T07A is a single-phase servo motor in the BMI series, delivering 5.4 N·m at 115 V single-phase input and 4.4 N·m at 230 V single-phase input. Rated power shifts accordingly: 750 W at 115 V, 1300 W at 230 V. The 100–240 V supply voltage range covers most single-phase mains without an external transformer. Feedback is absolute multiturn SinCos Hiperface – no homing cycle needed after power loss; position is retained. The motor has no holding brake, so the load must hold position through the drive’s holding torque or an external brake. Continuous stall torque is 6 N·m with a continuous stall current of 6 A. Peak capability hits 14.5 N·m (both voltage cases) with a 30 A peak current (3 s at 230 V). This defines the acceleration margin for inertial loads.
Integration details – mounting, protection, cooling
Flange size is 100 mm with international standard mounting holes (9 mm diameter) and a centring collar of 95 mm diameter by 3.5 mm deep. Shaft is 19 mm diameter by 40 mm length, untapped end – no keyway; a clamp-on coupling is expected. IP rating: shaft seal is IP54, housing is IP65. Suitable for washdown areas but the shaft seal limits immersion. Cooling is natural convection – no fan, so derate continuous torque if ambient exceeds the datasheet temperature range (not shown here, but thermal resistance depends on mounting surface and airflow). Electrical connection via a printed circuit board connector – plan for a mating header on the drive cable. Integrated EMC filter reduces conducted emissions below standard limits; no external filter required for typical industrial environments.
Sourced to order against your RFQ. We quote based on current factory allocation and can confirm firm delivery windows. No alternative MPN is needed; if you require a backup second-source, we can search the broader single-phase servo pool – but this exact code is the only one that guarantees the shaft dimensions, flange, and feedback type without adapter plates.