The CAD32AFE7 is a TeSys Deca control relay from Schneider Electric, built for switching control circuits in industrial panels. Its 3 NO + 2 NC pole composition gives you three normally-open and two normally-closed contact sets in one package, so it can handle both make and break functions in a single relay — useful for interlocking or dual-channel safety circuits where you need to switch a load and signal back a confirmation. Rated for utilisation categories AC-15, AC-14, and DC-13 per EN/IEC 60947-5-1, it's suited for switching electromagnetic loads like contactor coils, solenoid valves, and small motors. AC-15 covers inductive loads above 72 VA, which is where most control transformers and contactor coils land; AC-14 handles smaller solenoids and relays; DC-13 covers DC inductive loads typical in process valve control.
Certified to EN/IEC 60947-5-1, UL 60947-5-1, CSA C22.2 No 60947-5-1, GB/T 14048.5, and JIS C8201-5-1. That means it's accepted across Europe, North America, China, and Japan without additional testing — a BOM-line certainty for global OEMs shipping panels to multiple regions. The IP2X front-face protection (VDE 0106) keeps fingers and tools away from live terminals inside the enclosure.
Operates from -40 °F to +140 °F (-40 °C to +60 °C) without derating, and up to +158 °F (+70 °C) with derating — so it works in unheated warehouses or near ovens. Storage range is -76 °F to +176 °F (-60 °C to +80 °C). Rated for vibration: 2 Gn (5–300 Hz) when open, 4 Gn when closed; shock: 10 Gn open, 15 Gn closed. That's enough for most machine-mounted panels on conveyors or presses, but verify against your specific machine's shock spectrum if it sees repeated impacts above 10 Gn. Altitude rating to 9842 ft (3000 m) — fine for most installations, but if your site is above that, the air-insulation clearance derates and you'll need a different relay or a higher-rated device.
Dimensions: 1.8 in (45 mm) wide, 4.2 in (107 mm) tall, 3.7 in (93 mm) deep. Snap-in terminals mean it clips directly onto a DIN rail — no tools needed for mounting, just a screwdriver for the wiring.