The LP2K06013FD is a TeSys K reversing contactor from Schneider Electric, rated for 3-pole motor control in AC-3 duty up to 6 A at 440 V, with a 110 V DC coil and one NC auxiliary contact. It ships preassembled with the reversing power busbar — no separate wiring of the mechanical interlock or power crossover needed, which saves panel-build time on a reversing starter. The contactor also carries an AC-4 rating for plugging and inching duty, where the motor is reversed or stopped by counter-torque, which stresses the contacts harder. For a small reversing starter on a conveyor, pump, or fan, this part covers the common 3-phase motor range up to roughly 2.2 kW at 400 V.
IP20 finger-safe terminals (per VDE 0106) mean it can sit in a standard enclosure without additional shrouding on the line side. The preassembled reversing busbar keeps the phase crossover internal, so the only field wiring is the incoming power, the motor leads, and the 110 V DC coil circuit. The 110 V DC coil draws a holding current that depends on the specific coil power — verify the coil inrush and seal VA against your DC supply rating. The single NC auxiliary contact (1 NC) is typically wired into the opposite contactor's coil circuit as an electrical interlock, supplementing the mechanical interlock built into the reversing busbar assembly.