The LX1G3TLSEA is a Schneider TeSys contactor coil built for 3-pole contactors. It accepts a control voltage range of 200...500 V AC/DC, covering a wide range of control power supplies. Operating time spec (20...35 ms open, 40...55 ms close) tells you this coil responds fast enough for standard motor starting and stopping. If you're holding a spare for a conveyor or pump starter that cycles heavily, the 5 Mcycles mechanical durability means it outlasts most duty cycles before you need to swap it.
Wiring and Mounting Fit
Push-in terminals accept solid or ferruled stranded wire from 0.2 to 2.5 mm², AWG 26 to 12, with or without cable end sleeves. No screwdriver needed for the control circuit connection—saves time when you're rebuilding a panel after a coil failure and every minute of downtime costs production. IP20 rated (IEC 60529), pollution degree 3 per IEC 60947-1, and ambient operating range -13 to 140 °F (-25 to 60 °C). That's standard for enclosed panel installations; no special sealing required unless the cabinet is washdown-rated.
Standards compliance includes EN/IEC 60947-4-1, UL 60947-4-1A, and CSA C22.2 No 60947-4-1. That puts it on the same compliance footing as the contactor it mates with—no extra documentation chase for the quality folder.
The 200...500 V AC/DC control voltage range matches common control transformer outputs. Operating limits are 0.8...1.1 Uc and drop-out at 0...0.45 Uc, providing good brownout ride-through. Built-in bidirectional peak limiting coil technology suppresses voltage spikes on the control circuit. Maximum operating rate of 600 cycles per minute at 60 °C suits high-speed picking or sorting lines. For a spare that might go into a fast-cycling machine, this rating confirms the coil won't thermally saturate.