Motor ratings across supply voltages
The SH32052P02A1100 delivers 61.6 Nm nominal torque at 500 rpm on 115 V single-phase supply, 56 Nm at 1000 rpm on 230 V single-phase, 38.1 Nm at 2000 rpm on 400 V three-phase, and 28.4 Nm at 2400 rpm on 480 V three-phase — the speed-torque envelope shifts with the available line voltage, so drive sizing must reference the actual supply at the installation point. Nominal output power follows the same pattern: 3230 W at 115 V single-phase, 5860 W at 230 V single-phase, 7980 W at 400 V three-phase, and 7140 W at 480 V three-phase. Continuous power is listed at 7900 W, which aligns with the 400 V three-phase rating.
Feedback and environmental sealing
The absolute multiturn SinCos Hiperface encoder provides position feedback without a home cycle on power-up — the multiturn count tracks absolute position across 4096 revolutions, which matters for applications where the machine must resume from the last known position after a power loss. IP65 protection per IEC 60034-5 applies to both the motor body and the shaft bushing — the seal at the shaft exit is the wet-end barrier, so the motor withstands washdown in food, beverage, or outdoor installations without an additional cover.
Peak and continuous current limits
Maximum current Irms is 96.8 A, and the same figure applies as the 3-second peak output current — the drive must supply this peak for acceleration and deceleration transients. Continuous stall current is 25.7 A, which sets the thermal baseline for holding torque applications. Peak stall torque reaches 220 Nm across the 115-480 V three-phase range, while continuous stall torque is 64.9 Nm — the ratio between peak and continuous stall torque is about 3.4:1, typical for servo motors handling high-inertia loads during acceleration.
Mechanical interface and mounting
The motor uses an international standard flange with a 205 mm flange size, 180 mm centring collar diameter, and 14 mm mounting holes — this matches common servo motor mounting patterns for direct coupling to machine frames or gearboxes. Shaft diameter is 1.5 in (38 mm) with a smooth shaft end and 3.1 in (80 mm) shaft length — the smooth shaft accepts a keyless clamping hub or a keyway-mount coupling. Maximum radial force is 4200 N at 1000 rpm, derating to 2910 N at 3000 rpm, which governs belt/pulley or direct-coupling bearing life.