What it is and where it sits in a machine
The Schneider Electric SH3 SH32052P12A1200 is a three-phase servo motor in the SH32052P sizing reference, built on a 205 mm international-standard flange. It is the rotating half of a brushless servo axis — the drive amplifies position commands, the motor delivers torque, and the integrated absolute multiturn SinCos Hiperface encoder closes the position loop without an external feedback device on the machine frame. It is sold without a holding brake and cooled by natural convection, so the thermal envelope is set by the stator copper hot ceiling of 130 °C and the housing seal rather than by a fan or a brake's heat path.
Power and torque envelope across the voltage taps
Nominal torque follows the inverse: 61.6 N·m at 115 V single phase, falling to 28.4 N·m at 480 V three phase, because the same 7.9 kW envelope is being delivered at higher speeds (1000 rpm up to 2400 rpm across the same taps).
Drive-side matching and electrical constants
Maximum RMS current is 96.8 A and the 3-second peak output current matches it at 96.8 A — the peak is the acceleration reserve, the RMS is the thermal limit on cyclic duty, and the drive selected for this motor must clear both numbers without tripping on I²T.
Sealing for washdown and outdoor duty
Protection is IP65 on the motor body, IP65 on the shaft bushing, and IP67 on the housing per IEC 60034-5 — the housing rating is what carries a washdown or outdoor cabinet, and the shaft-bushing rating is what the seal must hold against coolant and cutting fluid creeping past the rotating seal. The electrical exit is a straight connector, single-unit pack, which keeps the panel-side IP chain intact when mated with the matching cable assembly.