SH3 frame, 10.6 kW continuous across 115 to 480 V
The SH32053P01A2000 is a three-phase AC servo motor in the Schneider Electric SH3 sizing family, drawing on a 205 mm international-standard flange and a 38 mm smooth shaft with no holding brake. The motor flange spans 8.07 in (205 mm) with a 7.09 in (180 mm) centring collar, matching the SH32053P sizing reference printed on the device short name SH3. It is built to pair with a Lexium-series drive through the listed Hiperface SinCos absolute single-turn encoder. Continuous power is rated at 10600 W, with nominal output that swings from 4450 W at 115 V single-phase to 10620 W at 400 V three-phase and 10100 W at 480 V three-phase, so the same frame covers a wide mains condition without re-sizing. Buyers specifying against a 400 V or 480 V three-phase feed land near the top of that envelope; a 115 V single-phase supply drops the continuous capability to under half.
Torque envelope: 40 to 330 N.m, 33.2 A continuous stall
Peak stall torque reaches 2920.7 lbf.in (330 N.m) for short-duration accelerations and holds, while continuous stall torque is 835.5 lbf.in (94.4 N.m) across the 115 to 480 V range. Continuous stall current is 33.2 A, with a 3-second peak output of 136.1 A.
Speed map: 500 to 2400 rpm across the supply range
The five-pole rotor and 172 V/krpm back-EMF constant set the field-weakening ceiling the drive will command above base speed. Buyers pairing this motor with a 400 V three-phase bus — the common industrial feed — see base speed near 2000 rpm and the full continuous torque band on the constant-torque region of the curve.
Mechanical fit: 489 mm length, 4500 N radial load
Overall length is 19.3 in (489 mm) with a 3.1 in (80 mm) shaft extension, mounting on an international-standard flange with 0.6 in (14 mm) bolt holes and a 0.2 in (4 mm) centring-collar depth. The 7.09 in (180 mm) centring collar diameter and 8.07 in (205 mm) flange lock the motor into the SH3 family footprint — replacement motors must match these dimensions for a drop-in gearbox or coupling swap. Shaft end is smooth (no keyway), so coupling choice is a clamp-style or shrink-fit element rather than a keyed bore. The electrical interface is a straight connector by default, with a rotatable right-angled connector variant available on the same frame for cabinets where the cable has to leave axially rather than radially.
Sealing, cooling, and the 130 °C copper hotspot
Cooling is natural convection — no integrated fan, so the cabinet or machine housing has to carry away the 10.6 kW of continuous dissipation at rated load. The motor body carries IP65 protection per IEC 60034-5; the shaft bushing holds IP54 without a shaft seal ring and IP65 with one, so the seal choice depends on whether the application sees washdown or splash at the through-shaft. The winding hotspot rating is 266 °F (130 °C), the thermal ceiling the drive's I²t model has to honour during cyclic overload. One motor per pack, shipped as a single unit ready for cabinet integration.
Sourcing posture for the SH32053P01A2000
Lifecycle stage reads as current on the listed record.