The VW3M1C10R10 is a preassembled pulse train input (PTI) and I/O cordset for the Lexium 28 servo drive family. It runs 1 m (3.3 ft) between the servo drive's SUB-D 50 connector and a free-end CN1 interface on the logic controller side — a straight shot for motion-control wiring on a panel or machine.
What the connector means for fit
The servo drive end terminates in a SUB-D 50 pin connector — that's the standard high-density D-sub found on the Lexium 28's CN1 port, which carries the pulse-train direction and encoder signals. The opposite end is unterminated (free end), so you land the individual conductors on your controller's terminal block or breakout board. No special crimp tool needed on the controller side; just strip and terminate per your PLC or motion controller's wiring diagram.