Mitsubishi AJ65SBTB2N-16S, CC-Link small type remote I/O unit, triac output, terminal block, 16 points, 0.6 A per point, 85 mA consumption.
| Parameter | Value |
|---|---|
| Station type | Remote I / O station |
| Withstand voltage | Between AC external terminal and ground: AC 2830 Vrms / 3 cycles (altitude 2000 m) Between DC external terminals and ground: AC 500 V 1 min |
| Maximum load voltage | AC 264 V |
| Over voltage category | II or less |
| Unit power supply voltage | DC 20.4 to 26.4 V (ripple ratio within 5%) |
| Load voltage distortion rate | Within 5% |
| Rated load voltage, frequency | AC 100 to 240 V, 50/60 Hz ± 5% |
| Maximum voltage drop during ON | AC 1.5 Vrms or less (at 0.6 A) |
| Minimum load voltage . current | AC 50 V 100 mA, AC 100 V 10 mA, AC 240 V 10 mA |
| Current | 85 mA or less (24 VDC, all points ON) |
| Maximum load current | 0.6 A / 1 point, 4.8 A / 1 common |
| Leakage current at OFF | 3 mArms or less (at 200 Vrms at 60 Hz), 1.5 mArms or less (at AC 100 Vrms at 60 Hz) |
| Parameter | Value |
|---|---|
| Maximum inrush current | 25 A 10 ms or less |
| Installation location | In the control panel |
| External wiring connection method | Communication part, unit power supply part: 7 points 2 piece terminal block (M3 screw) I / O power supply part, input / output part: 34 points Direct mounting terminal block (M3 screw) |
| Output response time OFF → ON | 1ms or less |
| Storage ambient temperature | -20 to 75 ° C |
| Operating ambient temperature | 0 to 55 ° C |
| Pollution degree | 2 or less |
| Surge suppressor | CR absorber (0.01 μF + 47 Ω) |
| Storage ambient humidity | 10 to 90% RH, non condensing |
| Ambient operating humidity | 10 to 90% RH, non condensing |
| When there is continuous vibration | Frequency: 5 to 8.4 Hz, One amplitude: 1.75 mm Frequency: 8.4 to 150 Hz, Constant acceleration: 4.9 m / s 2 |
| Depth | 40 mm |
| Width | 179 mm |
| Shipping weight | 1.4 Kg |
| External dimensions height | 50 mm |
| Mass | 0.35 Kg |
| ON → OFF | 1 ms + 0.5 cycles or less |
| Use elevation | 0 to 2000 m |
| Use atmosphere | No corrosive gas |
| Impact resistance | Meets JIS B 3502, IEC 61131-2 (147 m / s 2 , 3 times in each of X, Y and Z directions) |
| Estimated lead time | Usually ships in 1 - 10 working days. |
| Output common method | 16 points 1 common (terminal trapezoid 2 wire type) |
| Insulation resistance | AC external terminal all together and ground, DC external terminal collective to ground: 500 MV DC insulation resistance meter 10 MΩ or more |
| Number of output points | 16 points |
| Output isolation method | Photocoupler isolation |
| Number of occupied stations | 1 station |
The AJ65SBTB2N-16S: Each of the 16 outputs handles 0.6 A continuous, 4.8 A per common, with a maximum inrush of 25 A for 10 ms. Rated for AC loads 100–240 V, 50/60 Hz. The on-state voltage drop is ≤1.5 Vrms at 0.6 A. Those numbers fit solenoid valves, contactor coils, or indicator lights – any AC load that stays under the 0.6 A ceiling. Isolation is photocoupler, response time 1 ms or less off→on, 1 ms + 0.5 cycles on→off.
The unit weighs 0.35 kg.
No. The AJ65SBTB2N-16S is a CC-Link remote I/O station with 16 triac outputs, while the FX3S-20MR/ES is a PLC. They serve different functions and are not drop-in substitutes.
No related articles