Omron E2AS08KS02WPB2102MOMS Inductive Sensor, NC, 2 mm, IP69
Omron E2A Series, M8 flush inductive sensor, 2 mm, NC, 3-wire, 10–32 VDC, 200 mA, stainless steel, IP67/IP69K, stranded cable.
Specifications
| Parameter | Value |
|---|---|
| Series | E2A |
| Parameter | Value |
|---|---|
| Sensing distance, max. | 2 mm |
| Parameter | Value |
|---|---|
| Operating voltage, max. | 32 V |
| Operating voltage, min. | 10 V |
| Termination type | Stranded Wire, 3-Pin |
| Parameter | Value |
|---|---|
| Switching frequency | 1.5 kHz |
| Load current | 200 mA |
| Parameter | Value |
|---|---|
| Mounting type | Flush Mount |
| Length | 40 mm |
| Housing material | Stainless Steel |
| Parameter | Value |
|---|---|
| Operating temperature, max. | 70 °C |
| Operating temperature, min. | -40 °C |
| IP protection rating | IP67;IP69K |
Product details
Frequently asked questions
Will this sensor drop into a panel designed for the 2-wire E2AS08KS02WPD22MOMS?
No – the wiring is different. The 3-wire version (brown/blue/black) requires a separate signal wire; the 2-wire version uses the same two conductors for power and signal. The mechanical fit (M8 flush, 13 mm cube) is identical, but you'll need to re-terminate or change the cable.
What are the key specifications of this sensor?
It's a flush-mount M8 inductive sensor with a 2 mm sensing distance, normally-closed (NC) output, 200 mA load rating on 10–32 VDC, switching frequency 1.5 kHz, IP67 and IP69K protection, stainless steel housing, and 3-wire stranded cable.
The Omron E2AS08KS02WPB2102MOMS is an M8 flush-mount inductive proximity sensor from the E2A series. It detects ferrous metal targets up to 2 mm away and switches a normally-closed (NC) output. Rated for 200 mA load on 10–32 VDC supply, it's built for tight spots with a 13 mm cube body and stainless steel housing that shrugs off washdown – it carries both IP67 and IP69K. The 3-wire stranded cable (3-pin) gives you the flexibility to run the NC output and power separately. Switching frequency hits 1.5 kHz, fast enough for counting or position sensing on a small assembly line. Repeat accuracy within 10% means you can swap it out without recalibrating if the target distance stays under 2 mm.
Mounting and wiring reality
Flush mounting delivers 2 mm detection in steel. M8 stainless body, 3-wire cable, 10 mA draw.