The Omron E2E-X6MD28-T 2M is an M8 inductive proximity sensor from the E2E NEXT series. It is unshielded, giving a 6 mm sensing range on ferrous targets. The DC 2-wire configuration carries power and signal on the same pair, simplifying wiring in space-constrained panels. The output is normally closed — the switch opens on target detection, which is useful for fail-safe circuits where a broken wire or power loss is detected as a closed-loop break. Rated for dry-location applications; no IP rating is stated in the base spec, so treat it as suitable for clean, non-washdown environments. The 2-meter PVC cable is pre-wired, reducing installation labor.
The M8 barrel mounts through a standard 8 mm hole with two locknuts — no bracket required. Unshielded construction detects metal targets up to 6 mm away without needing a flush mount to metal. The 2-wire DC format lets you loop the sensor into a PLC digital input or relay coil without a separate power pair; just ensure the load has a low off-state leakage to avoid false triggering. No polarity marking on the 2-wire sensor means it works with either DC polarity, simplifying replacement in legacy circuits where wiring may not be consistent.