Tight integrator note
The E2EX30MB1TL305MOMS: This E2E-Next M30 non-flush inductive sensor detects ferrous metals up to 30 mm with a PNP normally-open output. Switching frequency at 100 Hz keeps up with moderate-speed part detection on packaging lines and conveyor transfer stations. Powered from a 10–30 VDC supply, it draws 16 mA; the 200 mA load current handles direct PLC inputs or small relays. The 5 m cable saves an additional junction box in many installations — run it straight back to the control cabinet if the run allows. Rated IP67, IP67G (gas-tight), and IP69K for high-pressure washdown environments — common in food and beverage packaging lines.
Cable-length and output comparisons
Compared to the 2 m cable version (E2EX30MB1TL302MOMS), this 5 m variant adds three meters of cable. No other electrical or mechanical difference — same M30 non-flush body, same 30 mm sensing distance, same switching frequency and output. The connector version (E2EX30MB1TL30M1OMS) is 2 mm shorter at 80 mm and uses an M12 connector rather than fixed cable. If your panel layout requires a connector for quick-change or the cable would be too long, that's the candidate. But the 5 m cable version is the simpler, one-piece solution for a fixed installation. For a normally-closed output, the E2EX30MB2L302MOMS (2 m cable, PNP NC) swaps the contact logic; the rest is identical.