Omron E2E-Next M30 inductive proximity sensor, PNP NO, 30 mm sensing distance, M12 4-pin connector, IP67/IP69K.
| Parameter | Value |
|---|---|
| Series | E2E-Next |
| Parameter | Value |
|---|---|
| Sensing distance, max. | 30 mm |
| Parameter | Value |
|---|---|
| Operating voltage, max. | 30 V |
| Operating voltage, min. | 10 V |
| Termination type | Connector, M12, 4-Pin |
| Parameter | Value |
|---|---|
| Switching frequency | 100 Hz |
| Load current | 200 mA |
| Parameter | Value |
|---|---|
| Mounting type | Non Flush Mount |
| Length | 80 mm |
| Housing material | Brass Nickel Plated |
| Parameter | Value |
|---|---|
| Operating temperature, max. | 85 °C |
| Operating temperature, min. | -40 °C |
| IP protection rating | IP67;IP69K |
| Parameter | Value |
|---|---|
| Construction form | M30 |
| Current consumption | 16 mA |
| Inductive sensor output type | PNP, NO |
The Omron E2EX30MB1TL30M1OMS is an M30 E2E-Next inductive sensor with a 30 mm sensing distance, PNP normally-open output, and non-flush mounting. Switching frequency is 100 Hz — enough for moderate-speed part detection on conveyors or machine positions. Power it from 10 to 30 VDC; it draws 16 mA quiescent and can switch up to 200 mA load. The brass nickel-plated barrel and IP67/IP69K ratings mean it holds up to washdown and coolant splash.
The length is 80 mm.
Not without changes. The 305MOMS terminates in a 5-meter cable, while this sensor has an M12 connector. You'd need to swap the cable gland for an M12 receptacle or use an adapter.
No related articles