The E2EX4B1T12M1OMS: The sensor switches at 1 kHz, handles a load current up to 200 mA, and operates on a 10–30 VDC supply with a quiescent draw of 16 mA. The housing is brass nickel plated, rated IP67 and IP69K, making it suitable for wet or high-pressure washdown zones common in food, beverage, and packaging lines. Temperature range spans -40 to 85 °C, wider than many earlier M12 flush-mount sensors, giving it headroom for outdoor or non-climate-controlled installations.
If you are currently sourcing or stocking the E2AM12KS04M1B14OMS, the E2EX4B1T12M1OMS shares the same M12 flush-mount form factor, 4 mm sensing gap, PNP normally open output, and M12 4-pin connector. The panel wiring and mounting footprint are identical — no rework needed for a drop-in swap. The E2E-Next extends the operating temperature from 70 °C to 85 °C and switches at the same 1 kHz. Quiescent current rises slightly from 10 mA to 16 mA, still within typical PLC input supply margins. In every functional dimension it is a direct upgrade while remaining pin-for-pin compatible.
Integration note
Flush-mount into standard M12 threaded holes; tightening torque per the datasheet (not reproduced here). The connector mates with standard M12 A-coded 4-pin cordsets. PNP NO means the output goes high when the target enters the 4 mm detection zone — watch polarity if replacing an NPN or NC variant.