At a glance
This Omron E2EX8B1T18M1OMS is an M18 inductive sensor from the E2E-Next family, flush-mounted and rated for 8 mm sensing distance on steel. Output is PNP normally open, switching at 500 Hz, which covers the majority of discrete position and presence checks in automation cells. The connector is a standard M12, 4-pin, so wiring is plug-and-play with common breakout cables. Brass nickel-plated housing gives it the durability for oily or humid environments, and the dual IP67/IP69K rating means it survives washdown cycles with hot water and high pressure — common in food and beverage lines. Current consumption sits at 16 mA, leaving margin on a 200 mA load output. Operating range is 10–30 VDC, with temperature tolerance from –40 to 85 °C.
Not a drop-in for E2AM12KS04M1B14OMS
The E2AM12KS04M1B14OMS is an M12 sensor with 4 mm range. This E2EX8B1T18M1OMS is M18 with 8 mm range—twice the sensing distance, larger thread, and a larger body. If your panel was designed around the M12 cutout, you would need a bushing or adapter ring; the connector is the same 4-pin M12, so the wiring harness can stay. Not a bare-metal replacement without mechanical change. For a true swap, compare mounting-hole diameter: M12 requires a 12 mm hole, M18 needs 18 mm. The electrical specs are close (both PNP, similar voltage range), but the physical difference rules out direct substitution.
Because it's active, you don't need to worry about last-time buys or alternate sourcing for a new BOM line. Standard lead times apply; we can confirm timing on a quote.