The E2EX8MB1T122MOMS: The M12 barrel is the standard form factor for industrial proximity sensors — the 18 mm hex nut and 12 mm threaded body fit the common drilled-hole pattern on machine frames and conveyor brackets. Non-flush mounting means the sensing face extends past the surrounding metal; the 8 mm rated range is measured on mild steel, so budget a correction factor of roughly 0.7× for stainless steel targets (about 5–6 mm usable range). The PNP normally-open output sources 200 mA at 10–30 VDC — this is the standard signal for a sinking PLC input card. The 800 Hz switching frequency means the sensor can detect targets passing at up to 800 per second, which covers most conveyor, indexing, and rotary applications without the PLC missing edges.
Washdown-rated housing — IP67, IP67G, IP69K
The triple protection rating covers three distinct wet environments: IP67 for temporary immersion, IP67G for high-pressure washdown with the G variant's enhanced seal against oil and coolant ingress, and IP69K for hot-water (80 °C) high-pressure (100 bar) sanitation cycles common in food and beverage lines. The brass nickel-plated housing resists corrosion from caustic washdown chemicals. The 2 m PVC cable is a direct termination — no connector to mate or seal, which eliminates a potential ingress point. The cable jacket must be glanded properly at the panel entry to maintain the IP rating at the wire end.