Skip to main content
Log in
Omron E3JM-10M4T-G-N — Photoelectric Sensors

Omron E3JM-10M4T-G-N Photoelectric Sensor, 10m Through-beam

MPNE3JM-10M4T-G-N

Omron E3JM-10M4T-G-N through-beam photoelectric sensor, emitter+receiver pair, 10 m range, IP66, terminal block – 12-240 VDC / 24-240 VAC.

$123.00Ref. price · indicative, final on quote
Sourced new & surplus through independent channelsAuthenticity-screened · ESD-safe packingListing updated Jul 2026

Specifications

E3JM-10M4T-G-N — Sensing
ParameterValue
Sensing distance10m
E3JM-10M4T-G-N — Other specifications
ParameterValue
Shock resistance(Destruction) 500 m/s2 3 times each in X, Y, and Z directions (Malfunction) 100 m/s2 3 times each in X, Y, and Z directions
Connection methodTerminal block
Directional angleBoth Emitter and Receiver 3° to 20°
Power consumption(DC) 3 W max. (Emitter 1.5 W max. Receiver 1.5 W max.) (AC) 3 W max. (Emitter 1.5 W max. Receiver 1.5 W max.)
Dielectric strength2,000 VAC, 50/60 Hz for 1 min.
IP ratingIEC 60529: IP66
Power supply voltage12 to 240 VDC±10%, ripple (p-p): 10% max. 24 to 240 VAC±10%, 50/60 Hz
Insulation resistance20 MΩ min. at 500 VDC
Ambient humidity rangeOperating: 45% to 85% (with no condensation), Storage: 35% to 95% (with no condensation)
Standard sensing objectOpaque:14.8-mm dia. min.
Ambient temperature rangeOperating: −25°C to 55°C, Storage: −30°C to 70°C (with no icing or condensation)
Light source (wavelength)Infrared LED (950 nm)
Ambient illumination (Receiver side)Incandescent lamp: 3,000 lx max.

Product details

Field note – E3JM-10M4T-G-N

Through-beam photoelectric sensor pair (emitter + receiver) with 10 m sensing distance on opaque objects down to 14.8 mm diameter. Infrared LED at 950 nm – alignment is tight: directional angle sits between 3° and 20° on both ends. Supply handles anything from 12 to 240 VDC or 24 to 240 VAC, so drop it into an existing AC panel without a separate DC supply. Terminal block connection makes field wiring changes faster than a pre-leaded sensor – no cutting or splicing.

The E3Z-LT81 is a smaller, 60 m through-beam with a red laser diode (655 nm), but it’s strictly 12–24 VDC and uses a pre-wired cable – not a terminal block. If your panel runs AC or needs a field-wirable sensor, the E3JM is the better fit. For a DC-only retrofit, the E3Z will not drop in without re-termination and a voltage check.

Frequently asked questions

Can the E3Z-LT81 replace the E3JM-10M4T-G-N without rewiring?

No – the E3Z-LT81 requires 12–24 VDC only and uses a pre-wired cable, while the E3JM accepts 12–240 VDC/24–240 VAC via terminal block. Panel re-termination and supply voltage check are needed.

MPN
E3JM-10M4T-G-N