What it reads and what it drives
The E5CC-RX2ABM-001 accepts RTD and thermocouple types B, E, J, K, L, N, PLII, R, S, T, U, W plus 0-20 mA and 0-10 VDC analog signals — covers most process sensors without an external signal conditioner. Three relay outputs handle on/off or PID control loops; the event input and heater fault detection features let it supervise a resistive heating element and flag an open-circuit condition without a separate current transformer module.
Panel cutout is a standard 45 mm square — drops into the same hole as earlier E5Cx and E5CC generations without re-punching the gland plate. Spring terminals on the rear: strip and push, no screwdriver torque check. The IP66 front seal holds up to washdown spray when the gasket is seated against the panel face. Supply is 100-240 VAC — common across global panel builds; no separate 24 VDC power supply needed for the controller itself.