Integrator's spec note
The Omron R88M1L75030CBS2 is a 1S-series servo motor delivering 2.39 Nm of rated torque at 3000 min⁻¹ output speed, drawing 3 A at the 323–528 VAC operating range. That torque figure places it in the mid-range of the 1S family — sized for indexing tables, pick-and-place axes, or conveyor diverters where the load inertia is moderate and the cycle demands consistent holding torque at speed. The 180 mm width and 100 mm square frame (100 mm height, 100 mm length) fit a standard motor mounting pattern; verify the pilot diameter and bolt circle against your existing bracket before committing the BOM line.
The 1S series uses a standard round-flange mount with bolt-through holes; the connector exits axially or radially depending on the cable option selected. In a food-and-bev line, the motor body is not IP69K-rated by default — if the application sees daily CIP with hot caustic, plan for a stainless-steel adapter or a washdown cover over the connector and shaft seal. The 3000 min⁻¹ base speed pairs naturally with a 10:1 or 20:1 gearbox for low-speed high-torque conveyor drives.