What the BMI0703T06F delivers as a sourced kit
Rated output is 700 W on 230 V single-phase supply or 400 W on 115 V, with nominal torque of 2.9 Nm (115 V) or 2.2 Nm (230 V). Peak stall torque reaches 8.6 Nm on both voltage variants, giving headroom for short overloads during acceleration or reversal. Feedback is absolute single-turn SinCos Hiperface, which eliminates home-find routines on power-up and is compatible with most modern servo drives that accept Hiperface protocols.
The 3 Nm holding brake is rated at the motor's own shaft; it holds the load at standstill without power to the motor windings. For vertical axes or Z-axes, this is the number that confirms the axis won't drop when the drive is disabled. Continuous stall torque of 3.4 Nm across the 115–230 V range tells you the motor can deliver full torque at zero speed indefinitely — useful for tensioning or clamping applications. The IP54 rating on the shaft and IP65 on the housing means the motor can be used in environments with splashing water or moderate dust, but the shaft seal is not fully submersible. Suitable for machine-tool enclosures or food processing areas with wash-down cycles — match the environment to the shaft protection.
For a BOM freeze or new design-in, this part is specifiable without obsolescence risk.
Integration checklist
Shaft diameter is 14 mm, shaft length 30 mm, untapped end. If you need a tapped shaft for direct coupling, this is not the variant. Electrical connection is via a printed circuit board connector — plan for a mating header or flying leads that interface to that connector family. Natural convection cooling: no external fan required, but the motor must be mounted with adequate airflow around the housing to stay within thermal ratings. Derating might apply if enclosed in a tight cavity.