The Schneider Electric LC1E09008N5WBSIN is a 4-pole contactor from the Easy TeSys Control range, rated 25 A in AC-1 utilisation category for resistive loads at up to 415 V AC. That AC-1 rating means it's sized for heater banks, lighting, or other non-inductive circuits — not motor starting, where the AC-3 duty class would apply.
Rated insulation voltage (Ui) is 690 V per IEC 60947-4-1, giving headroom for 400 V line-to-line systems. The rated breaking capacity is 72 A at 440 V, and the making capacity is 90 A at 440 V AC — both conforming to IEC 60947. That means it can close into and interrupt fault currents well above its continuous rating, which matters for coordination with upstream protection. The IP20 finger-safe terminals are standard for enclosure-mounted gear — no additional shrouding needed inside a closed panel. Mounts on DIN rail or plate. Screw-clamp terminals accept up to 6 mm² solid or 4 mm² flexible with ferrule on the power side. Tightening torque is 1.2 N.m for both power and control circuits — a common value that your existing torque driver handles without a change.
Protective treatment TH per IEC 60068 means it's tested for tropical/humid environments. No UL or CSA mark is listed in the spec record, so if your panel requires those, check the nameplate or request a variant.