The Schneider Electric LC1E12008V7IN is a 4-pole contactor from the Easy TeSys Control range, configured 2NO+2NC, and rated for AC-1 resistive loads at 32 A up to 415 V. This is a general-purpose contactor for switching resistive heating elements, lighting banks, or other non-inductive loads in control panels up to that current ceiling. The 850 °C glow-wire test per IEC 60695-2-1 confirms the moulded case is rated for fire resistance under fault conditions.
Sourcing Reality — Obsolete Status
A functional replacement will need to be selected from the current Easy TeSys or TeSys D ranges based on the same AC-1 current rating, pole configuration, and coil voltage — but pin-for-pin compatibility and footprint must be verified against the panel layout.
Mounts on DIN rail or plate. Width 45 mm, depth 80 mm, height 74 mm. It belongs inside a cabinet with a higher enclosure rating, not exposed on the plant floor.
Environmental and Operating Limits
The TH protective treatment with pollution degree 3 per IEC 60068 means it can handle the mildly corrosive atmosphere and conductive dust typical of industrial control rooms — not clean-room, not outdoor, but standard factory environment. Altitude rating to 3000 m without derating covers most installations outside high-mountain or unpressurised aircraft applications. The vibration and shock ratings — 1.5 Gn open, 3 Gn closed, 7 Gn shock open, 10 Gn closed — are typical for a contactor mounted on a DIN rail in a panel subject to normal industrial vibration from nearby rotating machinery.