The Schneider Electric LC1E1201Q7 is a 3-pole contactor from the Easy TeSys Control range, rated 12 A in AC-3 duty at up to 440 V. That AC-3 rating is what governs motor switching — it means the contactor handles the inrush and breaking of a motor load at that current, not just resistive heating. It carries a 380 V AC coil at 50/60 Hz and includes one NC auxiliary contact.
AC-3 covers starting and stopping squirrel-cage motors — the contacts see high inrush on make and break the locked-rotor current. If your motor full-load current is under 12 A, this contactor is electrically sized for it. The AC-1 rating covers resistive loads, so it could also switch heaters or lighting banks at a higher current, but AC-3 is the headline number for motor control. The 380 V AC coil matches a common industrial control voltage in many markets; verify your control transformer or PLC output supplies that voltage. The contactor meets EN/IEC 60947-4-1 (the standard for contactors and motor-starters), EN/IEC 60947-5-1 (control circuit devices), and GB/T equivalents. It carries IP2X finger protection on the front, so it is safe for open-panel installation where operators might reach in. The TH protective treatment means it handles condensation and humidity in non-condensing environments — fine for a dry control cabinet, not for direct washdown.
This class of contactor is used in motor control panels to switch three-phase motors on conveyors, pumps, fans, and compressors. It can also switch resistive loads like heaters. The DIN-rail mount and 45 mm width mean it slots into a standard panel layout alongside overload relays, terminal blocks, and other control gear.