The LC1E25004M7IN is a 4-pole contactor from Schneider Electric's Easy TeSys Control range, designed for resistive load switching under AC-1 utilisation category. It's rated for 50 A at up to 415 V, making it a fit for heater banks, lighting circuits, or other non-inductive loads in a control panel. Mounts on DIN rail or a backplate, with a compact footprint of 56 mm wide by 64 mm tall by 93 mm deep — sized for a standard enclosure without crowding adjacent devices. The IP2X finger-protection rating means the contactor's live parts are shielded against accidental contact during panel access, which is the minimum expected for enclosed industrial gear.
The AC-1 utilisation category is the key spec here: it governs resistive loads where inrush is minimal. At 50 A and 415 V, this contactor handles steady-state heater or resistor bank current without the derating needed for motor (AC-3) duty. If your application is inductive — motors, transformers — this part is not the right choice; you'd need an AC-3 or AC-4 rated contactor instead. Compliance with EN/IEC 60947-4-1 (contactors and motor-starters) and GB/T 14048.4 (Chinese national standard) covers most industrial installations globally, including CE-marked panels and projects requiring Chinese CCC certification.