The Schneider Electric LC1E25004V7IN is a 4-pole (4NO) contactor from the Easy TeSys Control range, rated for AC-1 resistive loads at 50 A up to 415 V (400 V operational). The contactor is designed for switching resistive loads in control panels — think heater banks, lighting, or other non-inductive circuits where AC-1 duty applies.
The AC-1 utilisation category at 50 A means this contactor is rated for switching resistive loads at that current — not motor starting (AC-3) or mixed loads. If your BOM calls for a 4-pole contactor on a resistive circuit up to 50 A, this part fits. The 4NO configuration gives four normally-open power poles; there are no auxiliary contacts built in, so factor in an external aux block if your control scheme needs N/C or signal feedback.
Operating altitude rated to 3000 m, ambient air temperature from -20 to 70 °C at coil rated voltage, with storage from -60 to 80 °C.
Physical integration
Dimensions: 56 mm wide, 64 mm high, 93 mm deep. The IP2X degree of protection means finger-safe from the front — suitable for enclosed panels where the contactor is behind a door or cover. The 93 mm depth is the dimension to watch when laying out the panel depth against the enclosure back wall.