85A resistive switching, 4P with mixed NO/NC
The LC1E65008Q7IN: The pole configuration is 2 normally-open and 2 normally-closed, giving you both make and break contacts in one block for circuits that need a mix — like heater banks with a separate control interlock. The 380 V coil means this is a standard mains-voltage pickup, common in panels where the control transformer feeds 380 V directly. Mounting is either plate or DIN rail, so it fits retrofit into an existing panel layout without a different footprint.
Obsolete — sourcing via independent channels
Schneider lists this part as obsolete. For a line-down situation or a BOM freeze, the part is available through independent surplus and broker channels — quantities are lot-specific and confirmed at RFQ. If you are holding an installed base of Easy TeSys Control contactors and need a drop-in spare, this is the exact part. For new designs, look at the current TeSys range for a functional equivalent — but the pinout and footprint may differ, so a panel layout check is needed before committing.
Environmental and mechanical ratings for plant-floor duty
The contactor carries IP2X finger protection on the body, so it is safe for open-panel mounting where operators might reach in. The TH protective treatment (pollution degree 3) means it handles conductive dust and humidity common in industrial environments without conformal coating. Vibration rating is 3 Gn closed (5–300 Hz) and shock rating 7 Gn closed for 11 ms, so it stays pulled in on a conveyor line or near a press. Altitude rating to 3000 m — no derating needed for most installations except high-altitude mining or mountain sites above that ceiling.
Compliance and standards coverage
That covers most global installations — IEC for Europe/Asia, GB for China. The 850 °C glow-wire test per IEC 60695-2-1 is a further safety marker for the housing material.