The Schneider Electric LC1E65008V7IN is a 4-pole (2NO+2NC) contactor from the Easy TeSys Control range, rated for resistive load switching under utilisation category AC-1. It carries 85 A at 400 V in the power circuit, making it a fit for heater banks, lighting panels, or other non-inductive loads where inrush is minimal. Mounts on DIN rail or plate, with an IP2X finger-safe enclosure.
Don't use this contactor for motor starting (AC-3) without derating; the coil and pole stack are optimised for low-inrush duty. The 4-pole configuration with 2NO+2NC gives you flexibility for dual-circuit isolation or interlocking in a single device. The TH protective treatment (pollution degree 3) means it's suited for industrial atmospheres with conductive dust or humidity — not clean-room, but fine for a typical factory floor.