The Schneider Electric LC1E80004M7IN is a 4-pole contactor from the Easy TeSys Control range, rated for AC-1 resistive load duty at 110 A up to 415 V, with a 220 V coil. It switches resistive loads — heaters, lighting banks, or transformer primaries — where inrush is low and the current curve stays clean. The 4-pole arrangement gives you two normally-open and two normally-closed main contacts, which is useful for splitting a load across phases or for two-wire control circuits that need a break before make.
The AC-1 utilisation category is the key rating: it certifies the contactor for resistive loads where the current is nearly in phase with voltage, so there is minimal arcing at break. That 110 A at ≤415 V is the full-load continuous current the main poles can carry and interrupt under those conditions. If your load is motor (AC-3) or inductive (AC-4), this contactor is not rated for that duty — the inrush and arc energy would exceed its design limits. The 220 V coil is a standard control voltage in many industrial panels, but it is not a dual-voltage coil — it pulls in and holds at 220 V nominal. The 850 °C glow-wire test (IEC 60695-2-1) confirms the housing material resists ignition under fault conditions.