The Schneider Electric LC1E80008Q7IN is a 4-pole contactor from the Easy TeSys Control range, rated for AC-1 resistive loads up to 110 A at 415 V. With a 4P configuration (2NO+2NC), it's built for switching resistive heating elements, lighting banks, or other non-inductive loads in industrial control panels. The 95 x 127 x 120 mm footprint fits standard DIN rail or plate mounting, and the IP2X finger-safe enclosure meets basic touch protection requirements.
The AC-1 utilisation category is the headline rating here — 110 A at 415 V. AC-1 covers resistive loads where the current inrush is minimal, so this contactor is not suited for motor starting (that would be AC-3 duty). If your BOM calls for switching resistive banks, this rating confirms the thermal capacity. The 4-pole arrangement with two normally-open and two normally-closed contacts gives flexibility for multi-circuit isolation or interlocking without adding auxiliary blocks. Environmental robustness includes an operating altitude up to 3000 m, protective treatment TH (pollution degree 3) for humid or mildly corrosive atmospheres, and vibration/shock ratings of 1.5 Gn open / 3 Gn closed for vibration and 6 Gn open / 7 Gn closed for shock. The permissible ambient temperature spans -20 to 70 °C at the coil, with storage down to -60 °C and operation from -5 to 55 °C. These specs mean it holds up in unheated enclosures or near process heat, as long as the coil voltage stays within the rated range.
The LC1E80008Q7IN complies with EN/IEC 60947-1, EN/IEC 60947-4-1, and EN/IEC 60947-5-1, plus the Chinese GB/T equivalents. These certifications cover the contactor for use in industrial control equipment across most global markets, including CE-marked installations.