What this controller brings to the panel
The Omron E5CC-RX3A5M-606 is a panel-mount temperature controller from the E5CC series, built for process loops where a relay output and RS-485 communications are the baseline requirements. It accepts inputs from thermocouples (Types B, C, E, J, K, L, N, P, PLII, R, S, T, U) and linear signals (020mA, 010V), so it covers most common temperature sensors and process transmitters without an external signal conditioner. The relay output switches On/Off or proportional (PID) control signals to the load — typically a contactor or solid-state relay driving a heater or cooler. The RS-485 port supports Modbus RTU communication, letting a PLC or SCADA system read the process value, setpoint, and alarm status, and write new setpoints or tuning parameters. Supply voltage is 100~240VAC, which covers standard single-phase mains in most regions without needing a separate control transformer. The LCD display shows four characters per row in white characters, with a 0.710" (18.00mm) main display and a 0.433" (11.00mm) secondary row for the setpoint or other data.
The controller mounts in a square 45.00mm x 45.00mm panel cutout — the standard 1/16 DIN footprint. Screw terminals on the rear accept the power, sensor, and communications wiring; no special crimp tool or backplane connector is needed. Ingress protection is IP20 on the body (finger-safe, suitable for a clean panel interior) and IP50 on the front face (dust-protected). The event input feature (two event inputs on this model) allows external dry-contact signals to trigger preset actions — for example, switching between two setpoints, holding the PID loop, or resetting an alarm. This saves a PLC digital input when the action is simple and local.
