Skip to main content
Siemens 3RW5245-6AC14

Siemens 3RW5245-6AC14 SIRIUS Soft Starter, 135 A, 200-480 V

MPN 3RW5245-6AC14
Active

Siemens SIRIUS 3RW5245-6AC14 soft starter, 135 A minimum, 200-480 V, Class 10A/10E/20E, PROFIBUS/Modbus RTU/Modbus TCP/EtherNet/IP/PROFINET, screw fixing, 203 x 210 x 393 mm.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

3RW5245-6AC14 specifications
ParameterValue
Mountingscrew fixing
Depth203 mm
Width210 mm
Height393 mm
Trip classCLASS 10 A (default) / 10E / 20E; acc. to IEC 60947-4-2
Service factor1

Product details

Motor starting capacity and trip class

The 3RW5245-6AC14: Rated 135 A minimum with a voltage range of 200 to 480 V, this SIRIUS soft starter covers the common low-voltage motor sizes in industrial plants — 75 kW at 400 V is a typical fit, though the exact motor FLA determines the frame. Trip class is configurable: default Class 10A, with selectable 10E and 20E per IEC 60947-4-2. The minimum load is 15% relative to the smallest settable Ie — important if you're soft-starting a lightly loaded pump or fan that draws well below the starter's full range.

Fieldbus and control integration

Native PROFIBUS, Modbus RTU, Modbus TCP, EtherNet/IP, and PROFINET standard communication are all on board — no external gateway needed for most modern PLC networks. PROFIenergy support is available when paired with the PROFINET communication module. Analog output is 4-20 mA default, parameterizable to 0-10 V with the High Feature HMI accessory. Remote reset is achieved by cycling the control supply voltage — useful for unattended restart after a fault clears. Firmware updates are supported, and an error logbook is available with special accessories — helpful for commissioning diagnostics and post-fault analysis.

Panel mounting and clearances

Screw-fixing mount, 203 mm deep, 210 mm wide, 393 mm tall. Mounting position allows vertical surface rotation ±90° and tilt ±22.5° front-to-back — not a strict upright-only requirement, which helps in tight enclosures. Required clearances: 100 mm above, 10 mm in front, 0 mm behind, 75 mm below, 5 mm to the side. The zero rear clearance means the unit can sit flush against the back panel — useful when gland plates or busbars limit depth. Shock resistance is 15 g / 11 ms, dropping to 12 g / 11 ms with potential contact lifting — spec this for mobile or vibrating equipment.

Approvals and compliance documentation

CE marking, UL approval, and CSA approval are all confirmed on this variant. The product category is hybrid switching devices under the SIRIUS brand. Service factor is 1 — no built-in overload margin beyond the set current; the trip class handles the protection. Torque control is not supported; this is a standard voltage-ramp soft starter, not a closed-loop torque controller.

MPN
3RW5245-6AC14