Skip to main content
Siemens 6EP1331-2BA10

Siemens 6EP1331-2BA10 SITOP PSU100M 0.5A Power Supply

MPN 6EP1331-2BA10

Siemens SITOP PSU100M, 6EP1331-2BA10, 24 V DC / 0.5 A regulated power supply, 120-230 V AC input, DIN rail mount, IP20, UL/CSA listed.

$34.29 – $98.00 Ref. price · indicative, final on quote
Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

6EP1331-2BA10 specifications
ParameterValue
Fuse protection typeT 2 A/250 V (not accessible)
Voltage24 V
Power12 W
Frequency47 ... 63 Hz
Phases1-phase
IP ratingIP20
MountingSnaps onto DIN rail EN 60715 35x7.5/15
Depth91 mm
Width22.5 mm
Height80 mm
Efficiency74%

Product details

The Siemens 6EP1331-2BA10 is a SITOP PSU100M series regulated switch-mode power supply that takes a 120-230 V AC line input and delivers a safety extra-low voltage (SELV) 24 V DC output rated at 0.5 A continuous. It snaps onto a standard DIN rail EN 60715 35x7.5/15, occupying just 22.5 mm of panel width — a single module slot. The 74% efficiency figure is typical for this class at full load; at lighter draws it runs cooler, which matters when you stack several units in a sealed enclosure.

The 0.5 A output at 24 V DC (12 W) is sized for small control loads: a handful of relays, a compact PLC, or a few sensors. It is not a motor-starter supply. The input accepts 120-230 V AC, 47-63 Hz, which covers single-phase mains globally. The internal fuse is a non-accessible T 2 A/250 V — if it blows, the unit is replaced, not repaired. The I²t rating of 0.3 A²·s tells you the inrush energy the output can handle; keep the capacitive load on the 24 V bus under that threshold to avoid nuisance tripping on power-up.

Snaps onto DIN rail EN 60715 35x7.5/15. The 22.5 mm width means it takes one standard module position — useful when you are filling a crowded row. Input terminals: L, N, PE each accept one 0.5-2.5 mm² conductor. Output side: one terminal for +, two terminals for - (allowing daisy-chain return wiring). The recommended upstream protection is a 3 A characteristic C miniature circuit breaker.

MPN
6EP1331-2BA10