The FRN0075G2S-2GU is a 25 hp FRENIC-MEGA drive from Fuji Electric, rated for 74.8 A continuous output at 200–240V AC three-phase. That 74.8 A figure is the current you size the motor and cabling for — it's the full-load ampacity the drive delivers, not a surge rating. The input accepts both single- and three-phase 200–240V AC at 50/60 Hz, so it'll run off a standard North American 240V panel or a European 230V line without a transformer. The 200% starting torque at 1 Hz means it can break a stuck pump or conveyor loose without oversizing the drive — common for high-inertia loads. Output frequency range of 25 to 500 Hz covers standard induction motors up to 400 Hz spindle drives, so it's not limited to 60 Hz base-speed applications. Enclosure is open-frame NEMA 1, so it needs a clean, dry cabinet — no washdown or dusty environment without a separate enclosure. The LCD keypad gives you local control and parameter editing; Ethernet port is onboard, so you can hook it to a plant network without an option card.
Approvals include cUL to UL508C, CSA C22.2 No. 14, CE to EN61800-5-1, and RoHS compliance. That covers North American and European installations — no extra certification needed for most industrial panels.
Physical dimensions: 15-3/4 in high, 9-7/8 in wide, 7-5/8 in deep. That's a compact frame for 25 hp — fits a standard 20x20x8 inch enclosure with room for line reactor and fusing alongside. The compact/heat sink style means the heatsink is integrated into the frame, so you don't need extra panel cooling for typical loads, but keep the ambient under 40°C for full rating. Control I/O: 9 digital inputs, 6 digital outputs, 3 analog inputs, 2 analog outputs, plus 2 safety inputs. That's enough for basic speed/start-stop with a PLC, plus a safe torque-off loop without an external safety relay. No brake chopper inside — if you need dynamic braking for vertical loads, plan for an external resistor and chopper module.