Skip to main content
Omron E5EC-TQQ4D5M-008

Omron E5EC-TQQ4D5M-008 Process Controller, 24VAC/DC

MPN E5EC-TQQ4D5M-008
Active

Omron E5EC-TQQ4D5M-008, E5EC-T series Process / Temperature Controller, 24VAC/DC supply, 4 Relay + 2 Voltage (External SSR) outputs, RS-485 CompoWay/F Modbus, IP66 panel mount.

Dispatch SLA24-48h Global Rush
Quality CheckOriginal Seal & Physical QC
IncotermsDAP / DDP Available
Source DocumentedChannel stated on listing & quote
Condition PhotosReal unit photos / video on request
WhatsApp AnswersFast human replies for machine-down parts
Worldwide DispatchDHL/FedEx — transit quoted per order
Independent China distributor & stockist· Listing updated Sep 2026

Specifications

E5EC-TQQ4D5M-008 specifications
ParameterValue
SeriesE5EC-T
Output signalRelay (4), Voltage (External SSR) (2)
Supply voltage24 VAC/DC
IP ratingIP66
ProtocolRS-485 (CompoWay/F, Modbus)
MountingPanel Mount
Temp operating max55 °C
Temp operating min-10 °C
Weight0.463 lb (210.01 g)
PackageBulk
Control methodOn/Off, Proportional (PID)

Product details

What the output mix buys you

The E5EC-TQQ4D5M-008: Four relay outputs handle direct on/off switching of contactors, solenoid valves, or alarm circuits up to the relay rating. Two voltage outputs drive external SSRs for PID-controlled heating zones where the cycle rate would wear out mechanical contacts. The 24VAC/DC supply rail means this controller runs off the same control transformer that powers PLCs and sensors in a typical panel — no separate 100-240VAC tap needed.

Sensor and input flexibility

Accepts RTD, thermocouple types B/E/J/K/L/N/PLII/R/S/T/U/W, plus 0-20mA or 0-10VDC linear process signals. That covers the full range from cryogenic RTD to 2300°C high-temp furnace work on one SKU. The heater fault detection feature monitors current draw on the load side and flags a broken heater or SSR short — a common failure mode in electric ovens and extruder barrel heaters that otherwise goes unnoticed until product quality drifts.

Panel fit and environmental sealing

Panel cutout is 92mm x 45mm, the standard 1/4 DIN horizontal footprint. Screw terminals on the rear — no special crimp tooling needed for field wiring. IP66 front panel rating means the display and keypad survive washdown spray. The gasket seals against the panel face, not the enclosure door — useful for food processing or outdoor cabinet installations where a hose-down is part of the sanitation cycle.

Communication and lifecycle

RS-485 port supports both Omron CompoWay/F and Modbus RTU. That lets a PLC or SCADA system read PV, setpoint, and alarm status without extra analog I/O cards.

MPN
E5EC-TQQ4D5M-008