The Mitsubishi HG-KN43 is a 400 W AC servomotor from the MELSERVO-JE series, delivering 1.3 Nm rated torque and 3.8 Nm peak torque at 3000 rpm rated speed, with a maximum speed of 5000 rpm. The 17-bit absolute encoder (131072 p/rev) provides position feedback resolution suitable for general-purpose motion control on indexing tables, conveyors, and pick-and-place axes. IP65 protection means the motor body withstands washdown and particulate ingress — no additional enclosure needed for food-grade or wet-area mounting, though the connector and cable entry still require proper sealing per the installation manual. The keyway shaft (not a keyless clamp) requires a matching key and set-screw torque per the drawing. No brake is fitted — the load must hold position through the drive's holding brake or an external mechanical brake. For vertical-axis applications or power-off holding, specify the braked variant or add a separate brake resistor and holding circuit.
Powered from a 200 V AC three-phase supply. The MELSERVO-JE drive (sold separately) handles the commutation and encoder feedback; the motor cable set includes the power and encoder lines. Verify the drive firmware revision supports the 17-bit encoder protocol — older JE-series drives may require a firmware update.