The F3SJ-A0960P25 is a 25 mm detection-capability light curtain from Omron's F3SJ-A series, rated for hand protection per IEC 61496. That 25 mm beam pitch means it catches a hand or finger reaching into the hazard zone — it does not detect a single digit, but it will stop a machine before a full hand enters the danger area. The 48 beams span a 960 mm protective height, so the guarded zone covers roughly a meter of vertical access. Operating range runs from 0.2 m to 9.0 m, which covers most machine-guarding distances on a production line — close up for a small press or out to 9 m for a wider conveyor entry. The 24 VDC supply is standard for safety circuits; no separate power supply module needed if your safety controller already provides 24 V. That suits washdown environments in food processing or packaging lines, but it is not rated for high-pressure spray or immersion — IP67 would be needed for hose-down at close range.
If you need a direct replacement, the closest parametric match is another F3SJ-A series curtain with the same 25 mm detection and 960 mm height — but verify the connector and mounting bracket compatibility against your current installation before committing the BOM line.
Integration notes for panel builders
The F3SJ-A0960P25 supports blanking and muting functions — blanking lets you disable specific beams for fixed obstructions (like a part fixture passing through the curtain), while muting temporarily suspends the safety function during a material transfer cycle. These are configured via the controller, not the sensor heads themselves, so factor in a compatible F3SJ controller unit for your safety circuit. Mounting brackets and alignment tools are available separately; the 20 mm beam pitch requires careful alignment to avoid nuisance trips from vibration.