The OD1-B015H05A14 is a 2D Laser Displacement Sensor from the OD Mini series, a compact chassis-mount unit delivering RS485 serial output over a 10.0mm to 20.0mm installation distance. Supply range is 12~24VDC, and the connector termination keeps field wiring clean for panel integration. Rated IP67 — dust-tight and protected against temporary immersion — so it handles washdown zones and damp floor-level mounting without a secondary enclosure. Operating temperature spans -10°C to 40°C, which covers most indoor production-floor conditions.
The 10.0mm–20.0mm installation distance defines the standoff from sensor face to target — not a measurement span but the allowable mounting gap for the 2D profile to focus. If your fixture holds the sensor at 15mm, you are in the middle of the range; at 8mm or 22mm the sensor will not lock a valid profile. RS485 output means the displacement data lands on a serial bus, not discrete IO. The 4-pin M8 connector carries power, ground, and the differential pair. Verify your controller's RS485 termination and baud-rate match before wiring. IP67 with connector termination — the sensor end is sealed, but the mating cable's IP rating determines the overall seal at the joint. Use an IP67-rated cordset to preserve the washdown rating.