The OD2-N120W60C2 is a 2D laser displacement sensor from the OD Value series, delivering a ±60 mm measurement range centered at a 120 mm standoff. That 120 mm nominal distance means the sensor sits 120 mm from the target surface and captures profile data 60 mm either side — useful for gap, flushness, or contour checks on a moving line. The NPN output (open collector) pulls low when the target is within range, so it interfaces directly with sinking PLC inputs or counter cards without a pull-up resistor. Supply is 12 ~ 24 VDC, which covers standard 24 V control power and 12 V battery-backed portable rigs. Chassis-mount form factor with cable leads (no connector) means it bolts to a bracket and the flying leads route through a gland plate; the kit is complete with the sensor and its cable, no separate connector to source. Installation distance is 60.0 mm to 180.0 mm from sensor face to target. Operating temperature is -10°C to 40°C.
Deployment context
This sensor is designed for chassis-mount installation — bolts to a bracket or machine frame, not a DIN rail. The cable leads exit the sensor body and route through a cable gland or strain-relief fitting on the panel wall. IP67 means the sensor itself is sealed against water jets and dust ingress, so it can be mounted directly in the washdown zone without a protective enclosure. Typical deployment: a conveyor line checking part presence, gap measurement between two components, or flushness of a pressed assembly. The 2D profile captures a line of points across the target, not just a single point — useful for detecting tilt or warp that a point sensor would miss.