The OD2-N50W10I0 is a 2D laser displacement sensor from the OD Value series, delivering NPN output over a 50 mm ±10 mm measurement window. The 40.0 mm to 60.0 mm standoff gives you a consistent working gap; the sensor reads the profile of the target, not just a single point, which is useful for gap, step, or alignment checks on moving parts.
Installation and signal
Mounts to a chassis via the housing — no DIN-rail clip, so plan for a bracket or direct bolt-down. The connector termination (M12-style, typical for this class) means you can pre-wire a cable assembly and swap the sensor without opening the panel. Operating temperature is -10°C to 40°C; if your line runs hot or near an oven, you'll need to keep the sensor out of the thermal plume.