Active production — what that means for the BOM line
The 1FL2102-2AF01-0HC0: The order code sits on the manufacturer's active list, so this is not a Last-Time-Buy item — quantity is quoted against the BOM and lead time is confirmed at RFQ rather than drawn from leftover stock (cite:,cite:). Group code R220 and product group X0DJ are the internal identifiers the ordering and shipping side reads back against the PO; matching these on the line item prevents a same-family variant being substituted at the dock (cite:,cite:).
What the motor is and what it pairs with
It is a SIMOTICS S-1FL2 low-voltage servo from the 1FL2 family, sized as a 50 W / 0.16 Nm continuous device with a 3000 rpm rated speed on a 400 V 3AC bus, and it is only valid in the driveline of a SINAMICS S200 — the drive, encoder resolution, and cable set are locked to that combination (cite:,cite:). Mechanical fit is a shaft-height-20 mm frame with a plain shaft (tolerance N), no holding brake, IP65 seal achieved through an oil seal rather than a smooth shaft — the motor is intended for the small-format SINAMICS S200 axis, not the larger 1FK / 1FT servos (cite:).
Ratings and what they mean at the panel
Pn 50 W with M0 / Mn both at 0.16 Nm defines this as a low-inertia point-and-pack axis — sized for small-format feeds, label applicators, valve actuation and indexing tables, not for continuous high-load processes (cite:). AS17 bit single-turn feedback is wired through the hybrid connector specified for the SINAMICS S200 drive system, so a replacement motor must reuse the same cable family or the encoder auto-configuration on the S200 will reject the part (cite:). IP65 with oil seal makes the motor acceptable for plant-floor ambient where oil mist is present, but it is not a washdown-rated enclosure — confirm the surrounding cabinet sealing separately if the line is hygienic-zone (cite:).
Compliance, packaging, and orderable handling
RoHS compliance has been in force since 01-01-18 and REACH Article 33 information is supplied with the product; the part ships under Siemens' product class C, which is built-to-order and not returnable for credit, so the requested quantity must be firm at PO entry (cite:,cite:,cite:). Order unit is 1 piece in a single-pack carton of 315 x 182 x 172 mm, no inner multiple — project spares should be ordered as whole-piece quantities against the BOM rather than cut out of a pack (cite:,cite:,cite:).