100 W low-inertia servo built around the SINAMICS S200
The Siemens 1FL2102-4AF10-0SC0 is a SIMOTICS S-1FL2 low-inertia servomotor in the 1FL2 product family, sized to pair with the SINAMICS S200 drive — a 400 V 3AC class, 20 mm shaft height unit rated Pn 100 W at Nn 3000 rpm, with M0 = Mn = 0.32 Nm of continuous and stall torque. The 0.32 Nm figure governs sizing: this is a small-format positioning axis, not a heavy-feed axis — think small-part pick-and-place, label applicators, secondary packaging, and compact indexing tables where the 20 mm shaft height and the 3000 rpm rated speed fit the mechanical envelope.
Holding brake, hybrid connector, IP54
The motor ships with a holding brake for vertical-axis or gravity-loaded applications where the rotor must hold position with the drive disabled, and connects via a hybrid connector carrying both power and the 21-bit absolute singleturn encoder feedback in one overmolded lead — no separate resolver cable to route. Protection class IP54 limits deployment to cabinet-internal or light-dust environments — the unit is not sealed for washdown or food-grade lines, and the configuration omits the oil seal, so the through-shaft end stays dry-side only. Plain shaft, tolerance N, no oil seal: this is the standard, non-sealed mechanical trim suited to couplings and small pinions in clean cabinet air, not to wet or outdoor cabinets.
Active lifecycle, custom-made order code
The order ships as one piece per quantity unit in a 315.00 x 182.00 x 172.00 mm pack, Group Code R220, Product Group X0DJ — useful for cross-referencing inside the Siemens configurator and for matching the BOM against a service replacement. Compliance: RoHS conformity since 01-01-18, REACH Art. 33 information on the candidate list supplied with the part, and no export-control flags (AL: N, ECCN: N) — shipment is not gated by export licensing for standard destinations.
Quoting and fit-out
Because the order code is a configured, made-to-order line item rather than a stocked SKU, availability and current pricing come back at quote time against the BOM — a panel builder or MRO planner locking a SINAMICS S200 axis should request the quote alongside the drive and the matching hybrid connector lead set so the build slot is reserved in one pass.