100 W, 0.32 Nm, 20 mm shaft — sized for a tight SINAMICS S200 cell
The 1FL2102-4AG11-1MC0 is a SIMOTICS S-1FL2 servomotor from the 1FL2 family intended for pairing with the SINAMICS S200 drive, built as a 200 V three-phase unit delivering Pn=100 W at Nn=3000 rpm with M0=0.32 Nm stall and Mn=0.32 Nm rated — a low-inertia package that closes short, repeatable motion segments typical of indexing, small-part pick-and-place, and labelling stations. Mechanically the motor is shaft-height 20 mm with a keyed shaft (tolerance N), an oil-sealed housing at IP65, and an integrated holding brake — that brake is what holds the axis still after a fast stop, so it matters on vertical or gravity-loaded axes where the carriage must not drift with the drive disabled. Position feedback is the AM21bit single-turn hybrid-connector encoder, which gives the S200 the resolution it needs for the short-index moves this 100 W frame is sized for — the drive and motor are sold as a matched pair, so substituting one without the other generally costs you the commissioning profile.
Active production, built to order — quote posture
The commercial class, however, is C: products manufactured / produced to order, which cannot be reused or re-utilized or be returned against credit — ordering is therefore a committed-BOM action with the manufacturer, and independent stocking tends to be lot-specific rather than continuous.